Jurassic Park Night Vision Goggles (Film Universe)

Sequence Gaps Detected!

The Jurassic Park Night Vision Goggles were specialised binocular goggles with night vision capabilities supplied in the Ford Explorer Tour Vehicles at Jurassic Park.

History

Jurassic Park Incident

Main article: Jurassic Park Incident (Film Universe)

Production Notes

Jurassic Park

Production

The various prop Goggles built for the film were constructed from the same basic items. The lenses were taken from Konica Aiborg cameras. These where unique in that they featured a fitted lens cap that retracted up into the lens as it was extended, adding an additional layer of motion to the film prop. The headgear used was the K117 by Huntsman, used on their welding helmets.

Jurassic World

Production

The last surviving pair of Night Vision Goggles from Jurassic Park were loaned by Universal Archives to Production for use in Jurassic World under the prevision they been return in the same, if not better condition. As they were intended to portray a pair that had sat dormant in the Visitors' Center Garage for over 20 years, the props department did a non-permanent age on the Prop. In the film, the left lens detaches from the housing as Gray uses the zoom mechanism. It is not clear if this was intended, or a malfunction of the Prop during shooting. All other behind the scenes videos of the prop in use show the lens remaining fastened in place during operation.